I have a 2016 Voodoo Hoodoo bike which has been great so far. My bottom bearing on the headset has been feeling rough so attempted to strip it down to inspect the damage. On removing the forks I couldn’t actually remove the bearing itself as I watched in some Youtube videos, where the bearings just ‘popped out’. I did apply some fresh TF2 grease but I suspect that this didn’t actually go into the bearing as it was cased. I am now assuming that I have a semi-integrated bearing setup on the Voodoo Hoodoo? Does anyone know if this is correct? And if so how I remove them to replace/assess damage.